|
Pipe Network Tools
An Assortment of Tools used to edit Pipe Network Parts (Pipes and Structures) in either Plan View or Profile View. Speeds up editing time and requires very little training in Pipe Network.
|
| 1 |
Set Pipe Invert - Start or End |
| 2 |
Set Pipe Slope - Downstream or Upstream |
| 3 |
Match Pipe Slope - Downstream or Upstream |
| 4 |
Set Pipe Cover - Start, End or Both |
| 5 |
Match Pipe Obvert - Downstream or Upstream |
| 6 |
Quick Pipe Design in Profile View - using Cover and Slope Rules |
| 7 |
Quick Pipe Invert Design using Entry Table |
| 8 |
Update Pipe Network using Excel Table Data |
| 9 |
Export Pipe Network Pipes and Structures to ASCII |
| 10 |
AutoAssign Pipes or Structures to Alignment |
| 11 |
Swap Pipe Size using Numeric Entry Match |
| 12 |
Match Pipe Size by Selection |
| 13 |
Swap Structure Size usinf Numeric Entry Match |
| 14 |
Match Structure Size By Selection |
| 15 |
Find and Replace Pipe Parts |
| 16 |
Show Part Information |
| 17 |
Draw Pipe Network using Lines and Circles, Label Network using Mtext |
| 18 |
Calculate Crossing between 2 Pipes |
| 19 |
Calculate Crossing between Pipe and 2D LWPolyline Utility |
| 20 |
Fix Crossing by adjusting Start, End or Both |
|
|
|
|
|
|
|
